RPM SC-770 Controller Module Replacement

Last Updated: 04/25/2025 1:43 AM

The following table lists all the components that make up the document.

Title Type Status Last Updated
Rapiscan CM-267 Conveyor Monitor
Device
Published
06/27/2024 1:02 PM
Rapiscan VM-250 Vehicle Monitor
Device
Published
10/14/2024 9:50 AM
Rapiscan TM-850 Rail Monitor
Device
Published
09/18/2024 10:28 AM
Rapiscan PM-700 Pedestrian Monitor
Device
Published
06/20/2024 11:38 AM
1402 - 7927 - Establish Initial Conditions; Remark:
Procedure Step
Published
09/30/2022 1:47 PM
7927 - Establish Initial Conditions
Instruction
Published
07/12/2023 12:23 AM
7268 - 7231 - Close lane; Remark:7233
Procedure Step
Published
04/27/2023 7:01 PM
9053 - Warning : Traffic should temporarily be rerouted or halted during conduction of this pr...
Annotation
Published
09/27/2023 9:09 AM
7231 - Close lane
Instruction
Published
04/18/2023 1:00 PM
7233 - Use orange safety (traffic control) cones to setup barriers. Practice establi...
Remark
Published
04/24/2023 12:18 PM
7269 - 7232 - Open RPM door; Remark:7234
Procedure Step
Published
04/27/2023 7:02 PM
7232 - Open RPM door
Instruction
Published
04/18/2023 1:02 PM
7234 - Open all doors needed to access components.
Remark
Published
04/19/2025 7:48 PM
8450 - 8449 - Collect and record parameters in SC-770 controller before removing if possibl...; Remark:
Procedure Step
Published
09/15/2023 3:34 PM
8449 - Collect and record parameters in SC-770 controller before removing if possibl...
Instruction
Published
09/15/2023 3:34 PM
7270 - 7235 - Power off RPM; Remark:7236
Procedure Step
Published
09/01/2023 7:57 PM
7235 - Power off RPM
Instruction
Published
04/24/2023 12:30 PM
7236 - Move LD-260 switch to OFF position. The PWR ON
Remark
Published
04/27/2023 4:25 PM
8448 - 8447 - Uninstall Faulty SC-770 Controller Module; Remark:
Procedure Step
Published
09/15/2023 3:37 PM
8447 - Uninstall Faulty SC-770 Controller Module
Instruction
Published
09/15/2023 3:37 PM
8445 - 8444 - Disconnect Ethernet and AMPHENOL cables on SC-770; Remark:8662
Procedure Step
Published
09/15/2023 3:45 PM
7792 - Note : It is good engineering practice to ensure all cables and connectors are label...
Annotation
Published
07/07/2023 2:17 PM
8444 - Disconnect Ethernet and AMPHENOL cables on SC-770
Instruction
Published
09/15/2023 3:41 PM
8662 - Top Cables
Remark
Published
09/20/2023 10:49 AM
8663 - Bottom Cables
Remark
Published
09/20/2023 10:57 AM
8239 - 8238 - Loosen SC-770 cover screws; Remark:8237
Procedure Step
Published
09/06/2023 4:14 PM
8238 - Loosen SC-770 cover screws
Instruction
Published
09/06/2023 4:03 PM
8237 - Use the medium Phillips screwdriver to loosen screws. The screws should be ca...
Remark
Published
09/06/2023 4:14 PM
9716 -
Remark
Published
10/13/2023 2:38 PM
8240 - 8235 - Pull cover straight out and away from SC-770 body before rotating lid down; Remark:9715
Procedure Step
Published
09/06/2023 4:18 PM
8236 - Caution : Do not rotate the lid down before pulling it straight away from the SC-770 bo...
Annotation
Published
09/06/2023 4:18 PM
8235 - Pull cover straight out and away from SC-770 body before rotating lid down
Instruction
Published
09/06/2023 4:17 PM
9715 -
Remark
Published
10/13/2023 2:36 PM
8246 -
Remark
Published
09/06/2023 4:32 PM
8667 - 8666 - Remove four (4) mounting screws; Remark:8665
Procedure Step
Published
09/20/2023 1:44 PM
8666 - Remove four (4) mounting screws
Instruction
Published
09/20/2023 1:41 PM
8665 - The mounting screws are located in a deep pocket in each corner of the ...
Remark
Published
09/20/2023 1:44 PM
8446 - 8443 - Remove SC-770; Remark:8668
Procedure Step
Published
09/15/2023 3:48 PM
8443 - Remove SC-770
Instruction
Published
09/15/2023 3:48 PM
8668 -
Remark
Published
09/20/2023 3:41 PM
3397 - 3395 - Label faulty component; Remark:3396
Procedure Step
Published
07/21/2024 6:59 AM
3395 - Label faulty component
Instruction
Published
08/07/2021 11:07 AM
3396 - Use tag or tape. Include date of removal, description of failure symptoms, co...
Remark
Published
08/09/2021 11:35 AM
8457 - 8456 - Install New SC-770 Controller Module; Remark:
Procedure Step
Published
09/15/2023 3:54 PM
8456 - Install New SC-770 Controller Module
Instruction
Published
09/15/2023 3:54 PM
8099 - 8093 - Install four screws; Remark:
Procedure Step
Published
07/31/2023 7:57 PM
8093 - Install four screws
Instruction
Published
07/31/2023 7:57 PM
8268 - 8261 - Close SC-770 module cover and tighten all screws; Remark:
Procedure Step
Published
09/07/2023 2:50 PM
8261 - Close SC-770 module cover and tighten all screws
Instruction
Published
09/07/2023 2:50 PM
8454 - 8453 - Reconnect Ethernet and AMPHENOL cables; Remark:8452
Procedure Step
Published
09/15/2023 4:02 PM
7811 - Caution : Proper connection of cables is critical.
Annotation
Published
07/07/2023 9:48 PM
8453 - Reconnect Ethernet and AMPHENOL cables
Instruction
Published
09/15/2023 3:59 PM
8452 - Connect Ethernet and AMPHENOL cables on top of SC-770, and AMPHENOL cab...
Remark
Published
09/15/2023 4:02 PM
7279 - 7249 - Return equipment to normal operating condition; Remark:
Procedure Step
Published
04/27/2023 4:13 PM
7249 - Return equipment to normal operating condition
Instruction
Published
04/08/2025 3:22 PM
7280 - 7250 - Power on RPM; Remark:7251
Procedure Step
Published
04/27/2023 4:14 PM
7250 - Power on RPM
Instruction
Published
05/01/2023 8:31 AM
7251 - Move LD-260 switch to ON position. The LED PWR ON
Remark
Published
05/10/2023 3:14 PM
8462 - 8451 - Verify SC-770 firmware version; Remark:8461
Procedure Step
Published
09/15/2023 4:19 PM
8254 - Note : If firmware version is not correct, perform procedure DET-RPM-RAP-CM02 to upd...
Annotation
Published
09/07/2023 2:56 PM
8255 - Caution : The firmware version must be correct to operate the system
Annotation
Published
09/07/2023 2:57 PM
8451 - Verify SC-770 firmware version
Instruction
Published
09/15/2023 4:04 PM
8461 - Enter “Program Mode” by pressing “0.” Enter the password 1234 ...
Remark
Published
09/15/2023 4:19 PM
8463 - 8460 - Program parameters into new SC-770; Remark:8459
Procedure Step
Published
09/15/2023 4:20 PM
8253 - Caution : To ensure proper RPM operation, careful attention must be paid when entering ...
Annotation
Published
09/07/2023 3:00 PM
8460 - Program parameters into new SC-770
Instruction
Published
09/15/2023 4:20 PM
8459 - Use parameters previously recorded in Step 1-3. If those were not recorded, t...
Remark
Published
09/15/2023 4:20 PM
8584 - 8458 - Exit programming mode; Remark:8554
Procedure Step
Published
09/17/2023 11:00 PM
8458 - Exit programming mode
Instruction
Published
09/15/2023 4:21 PM
8554 - On SC-770, press # button until main controller screen is di...
Remark
Published
09/17/2023 9:40 PM
7282 - 7254 - Confirm network connection; Remark:7255
Procedure Step
Published
04/27/2023 4:15 PM
7254 - Confirm network connection
Instruction
Published
04/27/2023 2:22 PM
7255 - Contact operators to confirm communications have been reestablished between RPM ...
Remark
Published
05/10/2023 3:15 PM
8670 - 319 - Perform operational test; Remark:8669
Procedure Step
Published
04/08/2025 2:20 PM
319 - Perform operational test
Instruction
Published
06/10/2021 8:31 PM
8669 - DET-RPM-RAP-RM03, RPM Operational Testing
Remark
Published
09/20/2023 4:18 PM
7842 - 7820 - Inform system operators upon completion of maintenance action; Remark:
Procedure Step
Published
07/07/2023 11:15 PM
7820 - Inform system operators upon completion of maintenance action
Instruction
Published
07/07/2023 10:02 PM
322 - 321 - Document maintenance actions; Remark:
Procedure Step
Published
06/17/2021 9:49 AM
321 - Document maintenance actions
Instruction
Published
04/21/2025 11:19 AM
2869 - 2585 - Document maintenance performed; Remark:2866
Procedure Step
Published
06/18/2021 5:58 PM
2585 - Document maintenance performed
Instruction
Published
07/09/2021 12:15 PM
2866 - Record observations, times, and results for the maintenance report.
Remark
Published
04/21/2025 11:39 AM
4706 - 4705 - Submit report; Remark:4864
Procedure Step
Published
06/29/2022 9:50 AM
4705 - Submit report
Instruction
Published
06/29/2022 9:50 AM
4864 - As specified by management or contractual obligations.
Remark
Published
07/28/2022 1:36 PM
Corrective Maintenance Procedure
Document Type
Published
03/02/2020 3:32 PM
30 minutes
Duration
Published
04/01/2020 11:35 AM
Upon failure of SC-770 Controller Module
Frequency
Published
09/15/2023 10:15 AM
Warning
Annotation Type
Published
03/02/2020 3:25 PM
Note
Annotation Type
Published
03/02/2020 3:25 PM
Caution
Annotation Type
Published
03/02/2020 3:24 PM
Technician 2
Skill Level
Published
04/09/2020 1:17 AM
Keys to access RPM
Replacement Parts
Published
04/27/2023 6:56 PM
Reflective safety vest if required
Replacement Parts
Published
06/20/2023 4:47 PM
Ladder; 2 meters, 6 feet tall; non-conducting if required
Replacement Parts
Published
07/02/2023 4:48 PM
Phillips screwdriver, small with 80 to 100 mm long shaft
Replacement Parts
Published
07/09/2023 1:06 AM
Phillips screwdriver, medium
Replacement Parts
Published
07/07/2023 11:39 PM
LD-260 Disconnect Switch Power Off
Image
Published
04/24/2023 12:49 PM
SC-770 top ethernet and AMPHENOL cables
Image
Published
09/20/2023 10:44 AM
SC-770 bottom ethernet and AMPHENOL cables
Image
Published
09/20/2023 10:47 AM
SC-770 Controller Screws
Image
Published
09/01/2023 5:56 PM
Loosen SC-770 cover screws
Image
Published
09/20/2023 1:14 PM
Loosen SC-770 cover screws zoom in
Image
Published
10/13/2023 2:17 PM
SC-770 lid cover removal instruction
Image
Published
10/13/2023 2:22 PM
SC-770 lid cover removal
Image
Published
09/06/2023 4:31 PM
Remove four mounting screws_0.png
Image
Published
09/20/2023 1:39 PM
Remove SC-770
Image
Published
09/20/2023 3:40 PM
LD-260 Disconnect Switch Power On
Image
Published
05/04/2023 3:37 PM