8191 - Caution : Rabbit board must be configured with correct firmware version before use....
Type
Caution
Rabbit board must be configured with correct firmware version before use.
8192 - Note : If Rabbit board is not pre-configured with correct firmware version, this mus...
Type
Note
If Rabbit board is not pre-configured with correct firmware version, this must be done manually by performing procedure DET-RPM-RAP-CM02 following installation of new Rabbit board.
Step 00
8193 - Verify Rabbit board firmware is correct
Verify Rabbit board firmware is correct
8194 - Enter Program Mode by pressing “0.” Enter the password ...
Enter Program Mode by pressing “0.”
Enter the password 1234 and press “#” (enter); navigate to:
1: Gamma
3: Advanced
3: Show Version
The displayed version number indicates the firmware version installed on the board. (e.g. 1.10.1H)