8382 - Note : Nano Controller installation may differ from configuration shown in this proc... Čítať viac o 8382 - Note : Nano Controller installation may differ from configuration shown in this proc...
8365 - Note : This component is no longer required. Čítať viac o 8365 - Note : This component is no longer required.
8312 - Note : Take care when removing springs, as they might snap back and become misplaced... Čítať viac o 8312 - Note : Take care when removing springs, as they might snap back and become misplaced...
8254 - Note : If firmware version is not correct, perform procedure DET-RPM-RAP-CM02 to upd... Čítať viac o 8254 - Note : If firmware version is not correct, perform procedure DET-RPM-RAP-CM02 to upd...
8232 - Note : There might not be any LED activity on the LD-260 when the RPM is turned off ... Čítať viac o 8232 - Note : There might not be any LED activity on the LD-260 when the RPM is turned off ...
8192 - Note : If Rabbit board is not pre-configured with correct firmware version, this mus... Čítať viac o 8192 - Note : If Rabbit board is not pre-configured with correct firmware version, this mus...
8034 - Note : A gamma hi fault may also occur during this step. If this is unacceptable, ei... Čítať viac o 8034 - Note : A gamma hi fault may also occur during this step. If this is unacceptable, ei...
8021 - Note : Because CF-252 sources also emit gamma radiation, a gamma alarm may also occu... Čítať viac o 8021 - Note : Because CF-252 sources also emit gamma radiation, a gamma alarm may also occu...
8013 - Note : Occupancy sensors must be disabled during testing of fault indications. Čítať viac o 8013 - Note : Occupancy sensors must be disabled during testing of fault indications.
7999 - Note : Move the source at least 10m from the detectors. Čítať viac o 7999 - Note : Move the source at least 10m from the detectors.
