DET-RPM-RAP-FC02

9125 - 9121 - Measure occupancy input voltage - Decision, Notes: 9041

~1.2 VDC [Occupied]
Go to
9120 - 9118 - Inspect Wiring and Connectors - Process, Notes: 9119
~3.5 VDC [Not Occupied]
Go to
9095 - 9093 - Replace SC-771 Controller Board - Formal Procedure, Notes: 9007
Note
9041 - Using a digital multimeter in DC mode,verify 15 VDC at TB1 pins 1, 2, and 3.
9123 - Measure the occupancy signal input voltage to the SC-771 controller board at ...
9102 - What is the measured voltage?

9126 - 9099 - Measure occupancy output voltage - Decision, Notes: 9041

~1.2 VDC [Occupied]
Go to
9125 - 9121 - Measure occupancy input voltage - Decision, Notes: 9041
~3.5 VDC [Not Occupied]
Go to
9098 - 9096 - Replace SCA-774 Board - Formal Procedure, Notes: 9007
Note
9041 - Using a digital multimeter in DC mode,verify 15 VDC at TB1 pins 1, 2, and 3.
9100 - measure the occupancy signal output voltage from the Control...
9102 - What is the measured voltage?

9128 - 9121 - Measure occupancy input voltage - Decision, Notes: 9041

~0 VDC [Occupied]
Go to
9126 - 9099 - Measure occupancy output voltage - Decision, Notes: 9041
~3.5 VDC [Not Occupied]
Go to
9105 - 9104 - What Occupancy sensor is currently installed? - Decision, Notes:
Note
9041 - Using a digital multimeter in DC mode,verify 15 VDC at TB1 pins 1, 2, and 3.
9122 - measure the occupancy signal input voltage to the Control pi...
9102 - What is the measured voltage?

9134 - 9132 - +15 VDC supplied to occupancy sensor? - Decision, Notes: 9115

Yes
Go to
9131 - 9129 - Occupy RPM - Process, Notes: 9130
No
Go to
9083 - 8997 - Start - Begin, Notes:
Note
9115 - Verify RPM is ON
9114 - Disable the door tamper switch with a magnet (or piece of tape for spring loa...
9041 - Using a digital multimeter in DC mode,verify 15 VDC at TB1 pins 1, 2, and 3.
9133 - measure the occupancy sensor input voltage at TB-2 Pin 19
9043 - Is there approximately +15 VDC present?
Flowchart Title
Pedestrian Monitor Will Not Occupy