8232 - Note : There might not be any LED activity on the LD-260 when the RPM is turned off ... Read more about 8232 - Note : There might not be any LED activity on the LD-260 when the RPM is turned off ...
8192 - Note : If Rabbit board is not pre-configured with correct firmware version, this mus... Read more about 8192 - Note : If Rabbit board is not pre-configured with correct firmware version, this mus...
8034 - Note : A gamma hi fault may also occur during this step. If this is unacceptable, ei... Read more about 8034 - Note : A gamma hi fault may also occur during this step. If this is unacceptable, ei...
8021 - Note : Because CF-252 sources also emit gamma radiation, a gamma alarm may also occu... Read more about 8021 - Note : Because CF-252 sources also emit gamma radiation, a gamma alarm may also occu...
8013 - Note : Occupancy sensors must be disabled during testing of fault indications. Read more about 8013 - Note : Occupancy sensors must be disabled during testing of fault indications.
7999 - Note : Move the source at least 10m from the detectors. Read more about 7999 - Note : Move the source at least 10m from the detectors.
8005 - Note : Move the source at least 10m from the detectors. Read more about 8005 - Note : Move the source at least 10m from the detectors.
7982 - Note : Document each step and verification on attached checklist Read more about 7982 - Note : Document each step and verification on attached checklist
7858 - Note : Most replaceable bit type screwdrivers will be too large in diameter to fit i... Read more about 7858 - Note : Most replaceable bit type screwdrivers will be too large in diameter to fit i...
7792 - Note : It is good engineering practice to ensure all cables and connectors are label... Read more about 7792 - Note : It is good engineering practice to ensure all cables and connectors are label...
