RPM SPY-2 to IXIO-DT1 Occupancy Sensor Conversion

Re-route pedestrian traffic.

Open all doors needed to access components.

Use a magnet to disable tamper switches for all open doors. Use adhesive tape to disable older mechanical switches. 

Move LD-260 switch to OFF position. The PWR ON LED will turn off.

Use a slotted screwdriver to pry the cover off from the side.

The IXIO-DT1 should come with the narrow field antenna installed.

If needed, the antenna can be changed. Remove cover. Install narrow field antenna stored in slot behind antenna mount. Replace cover.

Use erasable marker or pencil to draw a level horizontal line. Mounting hole height is 35 cm from top of cabinet door.

Use erasable marker or pencil to draw a vertical line.

Template provided with the IXIO-DT1 has a self-adhesive backing. Template may differ from picture shown. Match template lines with vertical and horizontal marks.

If available, use a center punch and hammer to create a dimple at each mounting hole location.

If available, use a center punch and hammer to create a dimple at center of wire passage hole.

Use a 3.2-mm (1/8-inch) drill bit.

Use an 8-mm (5/16-inch) drill bit.

Use the deburring tool

Mounting screws are included in the IXIO-DT-1 kit. Do not fully tighten screws. Enough room should be available to slide the sensor in place.

The wiring assembly is included in the IXIO-DT1 kit. Feed loose end of wiring assembly through hole.

Leave approximately 15 cm (6 in) of wire remaining outside of cabinet.

First, slide left side onto mounting screw.

Then, place right side over mounting screw and push down.

Use medium Phillips (PH2) screwdriver. Take care not to overtighten.

The angle is adjusted by manually rotating the antenna up or down. The default angle is approximately 15 degrees.

Do not remove existing occupancy sensor from door panel. Disconnect SPY-2 wiring from terminal block 2 (TB2). Existing wiring is normally connected at pin 16, pin 15, and pin 6.

New IXIO-DT1 cable should be routed along existing SPY-2 cable. Cable ties may be used to secure new wiring to existing wiring.

Red is power (+12 VDC) wire.

For models with older terminal blocks, it may be necessary to use a fork connector.

Black is the ground wire. White is the common wire

Green is the occupancy signal to the SCA-775 module.

Access wire penetration hole from back of the RPM door.

Do not move door. Door must remain stationary to prevent occupancy.

Move LD-260 switch to ON position. The LED PWR ON will illuminate.

The SC-770 controller will display "OK" following Power On Self-Test (POST) and background measurement. 

Create motion in front of occupancy sensor. While holding the door open and still, wave a hand or walk in front of the sensor.

IXIO-DT1 green sensor light will illuminate.

Left latch on the LCD screen will indicate a “closed” circuit.

SC-770 status will read “OCCUPIED”.

The cover should snap into place.

If used outdoors, sealant should be applied to top and sides of cover. Do not apply sealant along bottom of cover. Remove excess silicone with mineral spirits and rags. 

Remove magnets and/or adhesive tape from door tamper switches.

Record observations, times, and results for the maintenance report.

As specified by management or contractual obligations.