PackEye Reseat Power Supply Connections

Press and hold the power button for approximately 10 seconds until indicator lights are off.

Shoulder straps should be facing down.

The distribution box is usually located in the top of the backpack.

Rotate the collar counterclockwise and pull straight out. The battery cable can be identified by the two (2) interior prongs. Pliers may be needed.

Use small, slotted screwdriver.

Use small, slotted screwdriver.

Note location of wire ties for reassembly. Use wire cutter or scissors.

There are Velcro strips securing the power supply module to the FHT 681 amplifier. A slotted screwdriver might be needed to pry them apart.

Only remove the screws on the side with the charger connector. Use T-10 Torx screwdriver. Retain screws.

Components will slide out of the housing.

Check for loose connections, burn marks, and debris. Check battery for leakage, bulging, burn marks, and any signs of overheating.

Check for loose connections, burn marks, and debris. Check USB port for damage or loose connections.

If wires are soldered to the board, skip this step.

Ensure the black wire is connected closest to the edge of the board.

Align circuit board with third slot from bottom of enclosure and slide into place.

Verify gasket is aligned between housing and end panel before inserting screws.

Use T-10 Torx screwdriver.

The module will snap into place.

Align the connector and push in. Rotate collar clockwise and hand-tighten.

If desired, install new wire ties and cut off excess.

Use small, slotted screwdriver.

Notați observațiile și rezultatele pentru Raportul de întreținere corectivă.

As specified by management or contractual obligations.